These instructions are designed to assist with installation on many different truck models.  The exact location of factory bolts and flat clips may vary for your model.
 
NOTE:  As you progress with the install, check that the Mudflap remains square and plumb to the tire.
 
Step 1:  Un-package your new Mudflaps. Smooth side is rear side, tapered corner on top  is outside top edge. If applicable, Stainless Steel weights face rearwards.
 
Step 2:  Remove factory screws and/or bolts typically located at point (A).
 
Step 3:  Pull the fender liner (if present) slightly out from behind the fender well so you can replace the smaller factory U clips with the supplied larger U Clips with the threaded side to the rear.
 
Step 4:  Align the factory fender hole with the factory liner hole and the threaded U Clip and, using the provided Allen wrench, temporarily thread first 1/4 x 20 bolt thru both to realign the liner hole with the fender well hole. (B)
 
Step 5:  Place the Mudflap into the fender well and match up the pre drilled top hole in the flap with the top factory holes. Insert 1/4 x 20 button head bolt. 
 
Step 6:  Remove the first lower alignment bolt (placed in Step 4), position the Mudflap over the hole, and reinsert the bolt thru the Mudflap, washer and into the bottom U clip. Check for proper alignment to tire, and tighten both lower and upper bolts.
 
Step 7:  Slip the bottom longer end of the “FLAT CLIP” over the lower edge of the fender liner, (see point C) and tighten causing the clip to grip the fender liner firmly.
 
Step 8: Tighten all bolts .  Recheck monthly and retighten if necessary.

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~